The 1st step in making a rose leaf. Above is a 1018X3/8 solid round steel.

The six steps of making a rose leaf.

A piece of 1018 mild steel 1/2"X1/2" square solid. Used to make part of the boot rack.

These parts for the boot rack were each made from a 1/2" x 1/2" piece of mild steel like the previous picture.

Finished boot rack.

Seven pieces of seamless round mechanical round steel tubing. I have cut part of 2 sides of each one. I will forge a Devil's caw from each one using only the steel shown in the above picture.

The above piece I cut with a plasma arc. It will make a pecan shuck.
The round mechanical steel tubing will make the pecan.
Only the above 2 pieces are used to make the pecan.

From a piece of pipe to a Chili Pepper